home *** CD-ROM | disk | FTP | other *** search
/ Tech Arsenal 1 / Tech Arsenal (Arsenal Computer).ISO / tek-20 / radiomd3.zip / TNC1 < prev    next >
Text File  |  1990-09-12  |  2KB  |  41 lines

  1. TNC1
  2.  
  3. Switch Selectable Firmware on the TAPR TNC-1
  4.   By Lynn W. Taylor, WB6UUT  
  5.  
  6. Recently, I was faced with a dilemma.  New TNC firmware
  7. written by someone here in California offered some nice features
  8. not available with the standard TAPR firmware, while new software
  9. products for the Mac and supporting an earlier project required the
  10. standard fare.  Switching EPROMs (even with ZIF sockets) still
  11. required removing the screws in the case and reinitializing.
  12.  
  13. Studying the TNC design itself provided the answer:  The TNC
  14. presently "bank selects" two sections of NOVRAM by switching the
  15. high-order address bit.  If the existing 2764's in the TNC are
  16. replaced with 27128's would double the ROM capacity of the TNC. 
  17. Simply adding the high-order address bit to the NOVRAM bank select
  18. would then allow two versions of TNC firmware to be resident
  19. simultaneously, each with it's own bank of NOVRAM for operational
  20. parameters.
  21.  
  22. The modification can be performed simply as follows: 
  23.  
  24. 1)    Remove U5, U9, U10, U11 and U12.  
  25. 2)    On the component side of the board, follow the trace from U5
  26. pin 21 to the via near the zero in U10 on the silkscreen. 
  27. (note: a "via" is a small pad used to pass signals from one
  28. side of a board to another).  Verify this by measuring
  29. continuity from U10 pin 26 to the via, and from U5 pin 21 to
  30. the same via.  
  31. 3)    Cut the trace entering the via on the component side.  I also
  32. recommend cutting the same trace where it connects to JP-8 to
  33. eliminate the possibly of noise problems.  
  34. 4)    Add a wire from the via to pin 17 of U27 -- the NOVRAM "bank
  35. select" pin.  
  36. 5)    If you intend to bank select all 4 EPROMs (not necessary in
  37. my case), add a wire from U9 pin 26 to U10 pin 26.  
  38.  
  39. CONTINUED IN FILE TNC1.1
  40.  
  41.